Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Fort Worth Owner’s Guide

Ghost Controls keypad and intercom issues in Fort Worth usually come down to one of three things: a keypad membrane that has gone dead from sun exposure, a control board that no longer reads the keypad signal, or corroded wiring between the keypad and the gate opener. We stock Ghost Controls-compatible keypads and intercom components on the truck, and most replacements run between $180 and $390 installed depending on the model and whether the wiring needs to be pulled fresh. Same-day service is available for keypad swaps since we keep the common parts in inventory.

Call (682) 841-5749

The way most Fort Worth homeowners find out their Ghost Controls keypad has failed is simple: they punch in the code, the keypad beeps or doesn’t beep, and the gate just sits there. Sometimes it works after three or four tries. Sometimes it only fails when it rains. Sometimes the intercom buzzes but the voice is so garbled nobody can understand the delivery driver on the other end. Any of those is enough reason to get it looked at before you are locked out of your own driveway or stuck buzzing guests in from the kitchen window.

Which Ghost Controls Models This Applies To

Ghost Controls makes two keypad families: the wireless keypad (often sold as the AXWK or a kit-bundled version) and the hardwired keypad that connects directly to the opener control board terminals. The wireless keypad runs on a 9-volt battery and talks to the opener through a receiver, while the hardwired version sends signal straight through low-voltage wire to the KP or Keypad terminals on the board. If you are not sure which one you have, look at the back of the keypad: a battery compartment means wireless, screw terminals or a pigtail wire means hardwired. We see both versions across Fort Worth, from older residential installs in Wedgwood and Ridglea to newer builder homes in north Fort Worth and Keller.

The intercom side of a Ghost Controls setup is typically a wired call station at the driveway paired with a handset or base unit inside the house. The failure points there tend to be the call button contacts and the transformer that powers the intercom loop. Ghost Controls is not the same fitment as LiftMaster or Mighty Mule, so a universal keypad from the home center usually will not pair correctly with the Ghost Controls receiver. We default to OEM or Ghost Controls-approved parts for the keypad and receiver, and for intercoms we will tell you honestly whether an aftermarket station will work or if you are better off staying original. Latch and Post Gate Repair Fort Worth is an independent gate repair company and not affiliated with Ghost Controls.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• The keypad only works when you press the buttons hard or multiple times. This is the membrane or tactile switches wearing out. Sun and heat break down the rubber button layer, and once one key starts requiring extra pressure the rest are not far behind.
• The gate opens intermittently or not at all even though the keypad lights up. The keypad is sending a signal, but the receiver or control board is not acting on it. We check the receiver frequency and board terminals before condemning either part, because sometimes it is a loose wire and not a failed component.
• The keypad beeps when you enter the code but nothing happens. This often points to the opener being in a locked or vacation mode, a blown control board fuse, or a misbehaving limit switch rather than the keypad itself. It is a diagnostic step we run first so you are not paying for a keypad you do not need.
• The intercom crackles, hums, or cuts out mid-conversation. Low-voltage wire run through Fort Worth clay soil or along a fence line is vulnerable to nicks, corrosion, and moisture intrusion. A failing transformer produces the same crackle, so we check voltage at the station before replacing anything.
• The keypad dies after a rainstorm and comes back a day later. Water is getting inside the housing, usually through a dried-out gasket or hairline crack in the faceplate. Ghost Controls keypads are weather-rated, but five or six Texas summers will take the gasket out.

Replacement Cost & What’s Included

In Fort Worth, a Ghost Controls wireless keypad replacement with the part and labor typically lands between $180 and $260. A hardwired keypad runs a little more, usually $220 to $320, because we are pulling or repairing low-voltage wire at the same time. Intercom stations and handsets are the wide range: a simple call station swap starts around $240, while a full intercom station plus inside handset with new wire can reach $390 or more depending on distance and whether we are trenching or running along an existing fence line.

Every quote you get from us is written down before we touch anything, and the number on that page is the number you pay. The price includes the part, the labor, testing the opener cycle, and cleanup. Our work carries the 365-Day Done Right Promise: if the keypad or intercom we install is not right, we come back and make it right, no argument and no second invoice. We also back the parts we source with their manufacturer warranty and we tell you up front which coverage applies.

DIY or Call Us?

Keypads and intercoms are low-voltage, which means the safety stakes are not the same as working on a gate spring or a high-tension cable. But that does not mean DIY is always the smart route. The checks an owner can do safely without tools are simple: swap the 9-volt battery in a wireless keypad, look for an obvious crack or water inside the housing, and confirm the opener itself is plugged in and not on a tripped GFCI outlet. If you want to tighten a screw terminal on a hardwired keypad, shut off the opener power first and do not work on a live board.

Where Fort Worth DIY jobs go wrong is usually compatibility. A homeowner buys a generic keypad, wires it in, and the Ghost Controls board will not recognize it because the signal protocol is different. Or they replace the keypad but not the corroded wire behind it, and the new keypad fails the same way in six weeks. Our approach is to diagnose the actual problem once, quote the fix in writing, and get it right the first visit. If you are not sure what you have, describe the symptom when you call (682) 841-5749 and we will tell you whether it sounds like a battery, a board, or a wiring problem before we ever schedule the truck.

FAQs

Call Latch and Post Gate Repair Fort Worth

If your Ghost Controls keypad has gone quiet or the intercom sounds like it is underwater, call (682) 841-5749 and tell us what is happening. A live person answers around the clock, every day, and you will get a straight answer and a written price before any work begins. We lay down shoe covers and drop cloths before we step inside, and we leave a photo of the cleanup so you can see exactly what we saw when we walked out. Cody Beckman and the crew have been fixing gates and openers across Fort Worth since 2009, and the fix is right or it is free to make right.

Written by Cody Beckman, Owner, Latch and Post Gate Repair Fort Worth at Latch and Post Gate Repair Fort Worth, serving Fort Worth and nearby areas.